Chapters Transcript Preparing to Feed on Kangaroo OMNI™ Preparing the kangaroo omni enteral feeding pump for feeding to begin press the power button centered below the pump screen to turn on the pump. The prior settings screen will appear settings from the pump's previous use are retained to keep the settings from the previous feeding press. Keep settings otherwise press clear settings from there. You will see the load set screen follow the animated instructions on the screen to load the cassette. You can do so by sliding the bottom pegs of the cassette up into the slots, then locking the top into place. You will hear a click when the cassette has been installed correctly. The set loaded screen will also confirm that the pump has correctly identified the feeding set. The colors of the cassettes are different based on feeding mode. A clear cassette is for feed, only a blue cassette is for feed and flush. A green cassette is for thick formula. Be sure to hang the prepared bag or prefilled container. So the starting volume of fluid is 10 inches or 25.4 centimeters above the top of the pump. As shown on this screen, you can adjust rate, adjust flush if applicable skip prime or prime. You can also press the more options button on this screen. For more information. Please refer to the kangaroo Omni enter feeding pump instructions for use. Created by
